Drum to Disc Brake Conversion Question

Dave1695 · 09-10-2010, 10:49 AM

If you have a fixed caliper (as opposed to a floating caliper) DO NOT use anything larger than a one inch bore master. Your problem sounds like you still have air in the system. Did the master cylinder run dry while you were making the change over or if you installed a new master was it bench bled before installing. On a Camaro the upper hole in prdal arm is for manual brakes.

09-10-2010, 10:49 AM	#1
Dave1695 Member Join Date: May 2009 Posts: 160 Likes: 0 Liked 15 Times in 11 Posts	Re: Drum to Disc Brake Conversion Question If you have a fixed caliper (as opposed to a floating caliper) DO NOT use anything larger than a one inch bore master. Your problem sounds like you still have air in the system. Did the master cylinder run dry while you were making the change over or if you installed a new master was it bench bled before installing. On a Camaro the upper hole in prdal arm is for manual brakes.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode