Mopar X-block question

GTX JOHN · 10-13-2011, 02:55 PM

Standard Deck block are supposed to be 9.56 as I recall. To get to 9.10 is almost a .5 cut which is huge. I am skeptical that you would have a very good engine with that kind of Cut. I have a couple in the shop so I try to get a approximate measurement on the thickness when I get home Tuesday from FallFling Show if needed.

Disclaimer: I am not a machinist OR even remember what I had for breakfast
so all opinions I give should be independently verified.

10-13-2011, 02:55 PM	#1
GTX JOHN VIP Member Join Date: Jun 2009 Location: Boulder City, Nevada 89005 Posts: 2,742 Likes: 2,836 Liked 2,517 Times in 701 Posts	Re: Mopar X-block question Standard Deck block are supposed to be 9.56 as I recall. To get to 9.10 is almost a .5 cut which is huge. I am skeptical that you would have a very good engine with that kind of Cut. I have a couple in the shop so I try to get a approximate measurement on the thickness when I get home Tuesday from FallFling Show if needed. Disclaimer: I am not a machinist OR even remember what I had for breakfast so all opinions I give should be independently verified.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode