ceramic bearings

[69Cobra]

Originally Posted by BlueOval Ralph

This load vs losses has alot of holes it really depends on how input load you are using (no load vs 500 lb-ft) at no load a 9 inch would show more lose than say 500 lb-ft the 9" has less then as the whole gear Assm is locked down pinion has god front carrier bearings bad a pinion tail support the spool has the billet caps and the solid spanners. If I were building a new 9" center today I would use the High strengh steel case that Strange has and Ford the NASCAR teams are using these cases about 2 to 3 lbs lighter than the Nodular but a little maybee 8 heavier than alum. But everything will stay in place and not move!

Can you run an aftermarket Nodular case in Stock? I just got off skype from talking to my dad about putting together a new third member so I'm just wondering?