mallory hyfire VI problem

R. Thorne · 10-30-2011, 09:20 PM

Thanks, guys. Primary ohms resistance is .7 on msd coil and .6 on "recommended" Mallory coil, so I don't think that is the issue. Will check cap as suggested and try another set of wires also. Tach worked fine with MSD last week. Is the Mallory that much more "powerful" than the MSD? Also, per Mallory instructions "do not ground to engine block, ground to frame or chassis". MSD says ground to negative terminal of battery or engine block. Thanks, Ron.

10-30-2011, 09:20 PM	#3
R. Thorne Member Join Date: May 2009 Posts: 183 Likes: 74 Liked 101 Times in 34 Posts	Re: mallory hyfire VI problem Thanks, guys. Primary ohms resistance is .7 on msd coil and .6 on "recommended" Mallory coil, so I don't think that is the issue. Will check cap as suggested and try another set of wires also. Tach worked fine with MSD last week. Is the Mallory that much more "powerful" than the MSD? Also, per Mallory instructions "do not ground to engine block, ground to frame or chassis". MSD says ground to negative terminal of battery or engine block. Thanks, Ron.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode