Hemi Head Ruling

[Peter Ash]

Originally Posted by David Barton

If there is a section listed in Super Stock, it replaces whatever was said in the Stock rules. Anything that is a repeat rule is rewritten in the Super Stock section. And they left out the part about the valve cover bolt holes, end of story. Why would they write all that stuff about cylinder heads and leave out such an important rule, unless it was meant to be left out?

I'm sure if you asked every Hemi Super Stock guy out there whether or not their bolt holes were broken into, 95% of them would tell you yes. It's nothing new.

David

Whether or not 95% of the guys do it?

It is "THE RULE" HIGHLIGHTED on PAGE 1 SECTION 11 SUPERSTOCK


Right below the picture. First thing you can possibly read in the Superstock section.


Super Stock - Requirements and specifications for all Super Stock categories are the same for those as Stock with the following exceptions.

Absolutely NO mention anywhere of allowance to modify any VC bolt holes. But specifically mentioned in the stock rules as PROHIBITED ie., may not

hmmm, If it's been left out it must be one of those at least maybe possibly a 13 year oversite? Possibly longer if I recall my older rule books.

Cheers