2015 drag pack challenger

[James L Miller]

Originally Posted by Jim Wahl

Alan is correct, I was told I could not run an aluminum 8.75 center section even though they were available and standard equipment on some A body lightweight (for gas mileage) production vehicles and also available in some truck Dodge applications in the '70's. Jim.

From my recollection, the Feather Dusters and Dart Lites had aluminum transmission cases in the OD manual transmission, aluminum underhood panel, not the top skin which I think was steel (saw one in a junkyard with a scratch that was rusted), something aluminum in the bumper braces, I think it was the support behind the bumper. I don't recall any aluminum center sections. I doubt they put 8-3/4" axles in them since that ended in 1972 and those cars I think were 1975 or 1976 models. I think they were all slant sixes, so probably they got the 7-1/4" axle.

I have seen photos of a prototype aluminum 318 block. I think it was a Magnum 5.2L version.

[Jared Jordan]

So....when's Ma Mopar get forced induction? Hellcats don't count in this discussion.

[Dan Wilson]

If my upload works , this is the new dragpak supercharged HEMI!