Wheelie bar newbie

Mike Pearson · 10-24-2007, 09:49 AM

Todd,

I had the QA1 shocks on my car and they would not control the bouncing either. I purchased a set of shocks from Santhuff Engineering in Texas. They were Quite expensive but they are a hand built unit.They completly eliminated the front end bounce and the tires rubbing the inner wheel wells. They are a large diameter shock and will require some modification to the lower a arms. These shocks will cure your prolems. I picked up 3 tenths by fixing the bouncing and the rubbing of the front tires on the wheel wells

Mike

10-24-2007, 09:49 AM	#23
Mike Pearson VIP Member Join Date: Mar 2007 Posts: 2,454 Likes: 616 Liked 1,943 Times in 584 Posts	Re: Wheelie bar newbie Todd, I had the QA1 shocks on my car and they would not control the bouncing either. I purchased a set of shocks from Santhuff Engineering in Texas. They were Quite expensive but they are a hand built unit.They completly eliminated the front end bounce and the tires rubbing the inner wheel wells. They are a large diameter shock and will require some modification to the lower a arms. These shocks will cure your prolems. I picked up 3 tenths by fixing the bouncing and the rubbing of the front tires on the wheel wells Mike __________________ Mike Pearson 2485 SS

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode