Trans brake solenoid notes

Uncrated · 10-25-2007, 08:09 AM

In order to have more confidence in the connections and to make plugging/unplugging less fragile I soldered about twelve inches of 14 gauge leads onto the 20 gauge solenoid wires. An insulated clamp bolted at the speedometer hole now steadies both wires and serves as the ground. In addition, a male/female disconnect at the power wire completes the upgrade.

I feel much better now! [Grin]

Larry Woodfin

10-25-2007, 08:09 AM	#2
Uncrated Banned Join Date: May 2006 Posts: 170 Likes: 0 Liked 0 Times in 0 Posts	Re: Trans brake solenoid notes In order to have more confidence in the connections and to make plugging/unplugging less fragile I soldered about twelve inches of 14 gauge leads onto the 20 gauge solenoid wires. An insulated clamp bolted at the speedometer hole now steadies both wires and serves as the ground. In addition, a male/female disconnect at the power wire completes the upgrade. I feel much better now! [Grin] Larry Woodfin

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode