big base circle cam in stock elem.

[Bruce Noland]

Originally Posted by Bill Diehl

So what's the verdict here? Roller cam bearings? 60mm tunnel? offset lifters? Lifter dia?


lot of grey area to sort thru

60 mm tunnel, offset lifters, lifter diameter. What are you talking about? You went back 9 months for this? Do you race Stock or Super Stock?

[Adger Smith]

To quote Bobby " If it's not in the rule book it cannot be enforced. If that was the case they could make up any rule they wanted to and bounce someone just because they wanted to."
Dwight hit the nail on the head.
But you guys have forgotten about "The other Rule Book"
We may not be able to read it because "They Have It" It is called the " NHRA TECHNICAL POLICIES & PROCEDURES" manual. That is where the real rules that the Tech Dept follows are written. It pin points area like what is being discussed. Every Div Tech director should have one, somewhere & there should be one at every NHRA race. Between the "Rule Book" we get and their TECHNICAL POLICIES & PROCEDURES there should be no problem being consistent with rules.
BTY: This is the same manual that the AHFS rules and procedures are listed in.

[Bill Diehl]

Originally Posted by Bruce Noland

60 mm tunnel, offset lifters, lifter diameter. What are you talking about? You went back 9 months for this? Do you race Stock or Super Stock?

You will see me this year


C/S and D/S Boss 351 Ford

[Pedigo Perf]

Originally Posted by Bill Diehl

You will see me this year


C/S and D/S Boss 351 Ford

Only 8 days left, better hope for good WEATHER.

[JHeath]

Originally Posted by Bill Diehl

You will see me this year


C/S and D/S Boss 351 Ford

I can hardly wait.