|
|
|
|
06-14-2015, 09:08 PM
|
#1 |
|
Senior Member
Join Date: May 2004
Posts: 801
Likes: 1
Liked 10 Times in 6 Posts
|
Re: Clearance piston to valve
ghost, Did you check valve clearance with valve springs that you are going race with? you need a solid roller lifter the same height as your hydraulic roller to check cam lift & valve clearance, you will have more valve clearance with heavy springs. Tom
__________________
Tom Moock 5704 STK |
|
|
|
06-14-2015, 09:35 PM
|
#2 |
|
Junior Member
Join Date: Oct 2012
Posts: 81
Likes: 0
Liked 16 Times in 11 Posts
|
Re: Clearance piston to valve
Thanks for your help
tomorow, i check again with my race springs and solid lifters with same height |
|
|
|
|
06-15-2015, 08:40 AM
|
#3 |
|
Veteran Member
Join Date: Mar 2005
Location: Sand Springs, OK
Posts: 8,132
Likes: 896
Liked 390 Times in 170 Posts
|
Re: Clearance piston to valve
Doubt race springs will get him enough clearance.
__________________
Ed Wright 4156 SS/JA |
|
|
|
|
06-15-2015, 06:04 PM
|
#4 |
|
Junior Member
Join Date: Oct 2012
Posts: 81
Likes: 0
Liked 16 Times in 11 Posts
|
Re: Clearance piston to valve
after checking carefully with RACE spring . i have .038int and .065exh at 101.5 timing. Is tight but O.K. for my application
Thank's again |
|
|
|
|
06-15-2015, 07:00 PM
|
#5 |
|
Veteran Member
Join Date: Mar 2005
Location: Sand Springs, OK
Posts: 8,132
Likes: 896
Liked 390 Times in 170 Posts
|
Re: Clearance piston to valve
That is close with race springs. Hope it goes well for you.
__________________
Ed Wright 4156 SS/JA |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
