dart oil gallery

[Ed Wright]

With my Bowtie block and Isky Red Zone lifters, I had to do what Mike mentioned above here, to stop burning the top ends off my intake pushrods. Thanks Gary Hetler for that tip! I used a small 3 sided file. No restrictors. No more push Rod problems.
Having somebody like Mike Taylor help people here is great.

[carl hinkson]

Originally Posted by Ed Wright

With my Bowtie block and Isky Red Zone lifters, I had to do what Mike mentioned above here, to stop burning the top ends off my intake pushrods. Thanks Gary Hetler for that tip! I used a small 3 sided file. No restrictors. No more push Rod problems.
Having somebody like Mike Taylor help people here is great.

On ISKY lifter I have found sizing issues along with other builders out there, Every time I have had a customer send me those lifter I have had to get 2 sets to make up one set on one occasion it took 3 sets.

Here is just one page of many.

http://www.yellowbullet.com/forum/sh...1631930&page=5

[Ed Wright]

Originally Posted by carl hinkson

On ISKY lifter I have found sizing issues along with other builders out there, Every time I have had a customer send me those lifter I have had to get 2 sets to make up one set on one occasion it took 3 sets.

Here is just one page of many.

http://www.yellowbullet.com/forum/sh...1631930&page=5

Carl, I guess I have been lucky.

[carl hinkson]

Originally Posted by Ed Wright

Carl, I guess I have been lucky.

My self and alot of other guys who pay attention to detail have not been so lucky with there sizing.

Originally Posted by Bolt

I have to say, when Carl did my engine the lifters were a night mare. I can only speak for this one instance as it is the only lifters I bought.

They were all over the place in sizing. I called Isky they were nice enough about it, I sent them back, when Carl got the new ones they were still all over the map. So I called, they were nice about it, I sent them back again. When Carl got them for the third time and they were still all over the place in sizing, cost me $30.00 to ship them each time! Yep $90.00 in shipping, God knows because I cant remeber how much time I waited,the last set were close but had a lifter that was tapered.

It is what happened, so I hope they did get better about this issue, as it was some time ago. Now I wonder if I have the 8620 wheel, that would suck?

I probably see a few more lifters then you do, I have machined alot of lifter bores over the years and have seen about every lifter out there.

Go to the last post
https://www.facebook.com/cncblocks.n...02127783300404


Paying attention to details pays off and when you buy ISKY lifters that are not with in a .0015 or better this is what you might see.