Chrysler 8.75 for Aspen/Volare

Myron Piatek · 11-22-2017, 12:46 PM

I would have thought 5.13 for the short stroke 318 and 4.86 for a 360. But the higher the ratio, the weaker the smaller teeth are. 4.86 worked well for my crate 360. I was wondering at what point weight-wise one would consider going up a step. I'm still working on a Aspen wagon for J at almost 3,800 lbs!

The Dana 60 suggestion is a good one. Weight is hard on 8 3/4's and they're not as easy to check the teeth on.

There was a fast Mirada that ran an 8 1/4" rear for a long time. But I don't know any more details.

11-22-2017, 12:46 PM	#14
Myron Piatek VIP Member Join Date: Nov 2001 Location: Florida Posts: 1,542 Likes: 34 Liked 138 Times in 51 Posts	Re: Chrysler 8.75 for Aspen/Volare I would have thought 5.13 for the short stroke 318 and 4.86 for a 360. But the higher the ratio, the weaker the smaller teeth are. 4.86 worked well for my crate 360. I was wondering at what point weight-wise one would consider going up a step. I'm still working on a Aspen wagon for J at almost 3,800 lbs! The Dana 60 suggestion is a good one. Weight is hard on 8 3/4's and they're not as easy to check the teeth on. There was a fast Mirada that ran an 8 1/4" rear for a long time. But I don't know any more details. __________________ LOCOMOTION Racing Last edited by Myron Piatek; 11-22-2017 at 12:51 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode