Man. trans for Stock

[t.tosto]

They are still doing business but didn't seem too interested in drag racing trans. business at last years PRI show. Will check this year to see if anything has changed, at least hope in so far as to provide replacement parts. Tony Tosto

[gmonde]

I called them today ,,I have a dr-4 wide gear trans and looking to see if they still support parts ,, the response was they only support the dr-4 revision 4 only ,I have to get back with them with my serial number ,, how can I tell if is a revision 4?

[terry1]

I bought an input shaft and a billet release bearing retainer for my
DR-4 about two months ago. No problem.
I believe that when the input shafts are gone, that's it for them.
No sure if the RB retainer will/would be compatible with the
newer DR-4 Rev 4.
I have not seen a DR - 4 Rev 4, so I am not sure what to look for.
I DO know that a DR-4 can not be made into a DR 4 Rev 4; maybe
every one knows that, oh well!!!.
Terry K

[gmonde]

I have been looking for the serial number for jerico,,is it located under the cover (drivers side top)

[joe collins]

drivers side right below top cover

[gmonde]

there is only a casting number on the case 2174f04
nothing that's been stamped in case on the left side ,I checked the trans ear as well

[terry1]

The SN# of my DR-4 is 4942SCN.
I got this # off of my orig invoice.
I don't have access to my trans so I am not
sure where the SN# is.
I thought this my help in determining if the #'s
you see are indeed SN#'s.
Terry K