Chevy Al 1 1/16" bore

Eman · 12-17-2018, 03:58 PM

Is this for a manual brake set up? For an aluminum GM master cylinder I'd look at an S-10 with manual brakes. I've used a GM MC from an early 80's fullsize pickup before but they are cast iron. Most GM aluminum master cylinders were made for power assist and the problem with them is they are made to mount at an angle, the resevoir is the problem.
I wouldn't worry about a residual ck valve unless the MC is lower than the brakes.

12-17-2018, 03:58 PM	#5
Eman Member Join Date: May 2014 Location: E TN Posts: 473 Likes: 16 Liked 133 Times in 76 Posts	Re: Chevy Al 1 1/16" bore Is this for a manual brake set up? For an aluminum GM master cylinder I'd look at an S-10 with manual brakes. I've used a GM MC from an early 80's fullsize pickup before but they are cast iron. Most GM aluminum master cylinders were made for power assist and the problem with them is they are made to mount at an angle, the resevoir is the problem. I wouldn't worry about a residual ck valve unless the MC is lower than the brakes.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode