Pro trans help

Richard Kay · 09-02-2019, 05:49 PM

904 and 727 use the same filter. Pan gasket is different

ss3011 · 09-02-2019, 06:28 PM

Some use a bottom opening filter which I think is adapted from a 518 .

Eman · 09-03-2019, 11:46 AM

Do your filter and your trans a favor and put a couple of magnets in the pan. If it's an aluminum pan JB weld them in.

Tadshy · 09-05-2019, 12:31 AM

Thanks for all the help. It ended up being a filter from a 518. Great advice on the magnets too. I will definitely epoxy a couple to the bottom of the pan.

09-02-2019, 05:49 PM	#1
Richard Kay Junior Member Join Date: Oct 2004 Location: Long Island Posts: 33 Likes: 24 Liked 19 Times in 9 Posts	Re: Pro trans help 904 and 727 use the same filter. Pan gasket is different __________________ Valiantrich

09-02-2019, 06:28 PM	#2
ss3011 Senior Member Join Date: Feb 2002 Location: Southeast Michigan Posts: 909 Likes: 70 Liked 239 Times in 114 Posts	Re: Pro trans help Some use a bottom opening filter which I think is adapted from a 518 .

09-03-2019, 11:46 AM	#3
Eman Member Join Date: May 2014 Location: E TN Posts: 473 Likes: 16 Liked 133 Times in 76 Posts	Re: Pro trans help Do your filter and your trans a favor and put a couple of magnets in the pan. If it's an aluminum pan JB weld them in.

09-05-2019, 12:31 AM	#4
Tadshy Junior Member Join Date: Nov 2018 Location: Peoria, AZ Posts: 19 Likes: 12 Liked 1 Time in 1 Post	Re: Pro trans help Thanks for all the help. It ended up being a filter from a 518. Great advice on the magnets too. I will definitely epoxy a couple to the bottom of the pan.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode