NHRA 2020 Rule Amendment SS Intakes???

[bykr]

Originally Posted by SSDiv6

When Dave Smith (ProTrans) and his brother ran their 383 'Cuda many years ago, it had an adapted BBC intake.

The BBC has a pitch of 4.84 and the Mopar BB has 4.80. The port runner layout for both is: 00 00

How about fitting a 351-C intake on an FE engine? It can be done with the adapter shown below:




Engine builders and racers can get creative in many ways.
Nevertheless, what is the fuzz all about when they allow sheet metal intakes?

As a matter of fact, Buicks are adapting Mopar intakes.

That FE intake adapter is junk.No one runs it that I know of.

[Sean Cour]

Originally Posted by bykr

That FE intake adapter is junk.No one runs it that I know of.

Does it really matter? It shows this shyt has been around, and other builders are using it, other than sbc offenders!

[bubski]

Nobody is gonna question Gulius's innovation n pushing the limits of the rules !! A true innovator !! However he's just as good of a salesman !! Your new [legal heads] will probably be faster than the old ones !! just fork up the cash n maybe get a sheetmetal intake so it won't look so obvious !!

[Jeff Niceswanger]

Originally Posted by bubski

Nobody is gonna question Gulius's innovation n pushing the limits of the rules !! A true innovator !! However he's just as good of a salesman !! Your new [legal heads] will probably be faster than the old ones !! just fork up the cash n maybe get a sheetmetal intake so it won't look so obvious !!

You must not have heard.There won't be any new heads from the Gulius shop. He shut down and sold his equipment .

[Mike Gray]

Originally Posted by bykr

That FE intake adapter is junk.No one runs it that I know of.

It was never built for SS, I suppose you have first hand knowledge why it’s “junk”?

[Monte Howard]

I have one question after reading all this. Is a sheet metal Intake legal on a traditional Superstock engine?

[JeremyDuncan]

Originally Posted by Monte Howard

I have one question after reading all this. Is a sheet metal Intake legal on a traditional Superstock engine?

Yes

[Randall Klein]

Hope so
Been running my Grumpy Jenkins intake since the late 90's, been torn down 9 times
See ATTENTION IN THE PITS episode1
SS/NA 265/225 dual 4's on Grumpy intake.....any manifold that fits under stock hook

Randall Klein

[Bryan Worner]

Originally Posted by Mike Gray

It was never built for SS, I suppose you have first hand knowledge why it’s “junk”?

So was it built for Stock, where it was really illegal???

[Rich Biebel]

http://fepower.net/Products/feiamr.html