MSD 6425 and 2 step?

[Hacksaw]

You should have 4 wires from the 2 step. Grey tied in to tach and Ign box, Red to 12 v, Black to ground and Blue to switched 12v ( normally open ).

[cad]

Was it a new 2 step? No red light when activated by 12v on the blue wire?

[Jeff Stout]

Originally Posted by cad

Was it a new 2 step? No red light when activated by 12v on the blue wire?

Red light does come on when activating

[Jeff Stout]

Originally Posted by Hacksaw

You should have 4 wires from the 2 step. Grey tied in to tach and Ign box, Red to 12 v, Black to ground and Blue to switched 12v ( normally open ).

That is correct. It still wont activate. 12v from brake button to blue wire when activating.

[Hacksaw]

???? Did you check with a volt meter that you are energizing it with 12 volts? You maybe losing voltage if your going through a brake light switch. That's all I got.

[Jeff Stout]

Originally Posted by Hacksaw

???? Did you check with a volt meter that you are energizing it with 12 volts? You maybe losing voltage if your going through a brake light switch. That's all I got.

Actually going to check right now for 12 volts at button

[Hacksaw]

Figure it out?

[Jeff Stout]

Originally Posted by Hacksaw

Figure it out?

Check things out again and now it works. Thinking new button is suspicious. So damn hot out here making it tough to work.