|
|
|
|
08-09-2020, 07:47 AM
|
#1 |
|
Senior Member
Join Date: Feb 2009
Posts: 971
Likes: 430
Liked 205 Times in 93 Posts
|
Re: leaking th400
thankyou everyone for your help! ive have the fluid level to the dipstick full mark, WITH the deep pan on...did not remark the full mark...2 3/4" deep pan.
Last edited by richie 2; 08-09-2020 at 09:08 AM. |
|
|
|
08-09-2020, 09:49 AM
|
#2 |
|
Member
Join Date: May 2011
Location: Auburndale,Florida
Posts: 220
Likes: 29
Liked 71 Times in 38 Posts
|
Re: leaking th400
Fluid level cold should be at “add 1 pint” ATF will expand as it heats up.
|
|
|
|
|
08-09-2020, 10:01 AM
|
#3 |
|
Senior Member
Join Date: Feb 2009
Posts: 971
Likes: 430
Liked 205 Times in 93 Posts
|
Re: leaking th400
1 1/2" ...full mark to dipstick end.
|
|
|
|
|
08-09-2020, 10:11 AM
|
#4 |
|
Member
Join Date: May 2011
Location: Auburndale,Florida
Posts: 220
Likes: 29
Liked 71 Times in 38 Posts
|
Re: leaking th400
Are you using the oem dipstick and tube or an aftermarket ? Even with a deep pan I believe the fluid level should be below the pan rail. If it’s an aftermarket dipstick try draining the pan so the oil level shows about 1/4 up the dipstick cold. Then go for a test drive heat cycle the trans and recheck to see if the oil level is at full when hot.
|
|
|
|
|
08-09-2020, 10:46 AM
|
#5 |
|
Senior Member
Join Date: Feb 2009
Posts: 971
Likes: 430
Liked 205 Times in 93 Posts
|
Re: leaking th400
we originally had a fancy milodon unit. i thought it was the leak source, went back to the factory piece. will get it sorted out and go back to fancy...
|
|
|
|
|
08-09-2020, 10:58 AM
|
#6 |
|
VIP Member
Join Date: Dec 2001
Location: Texarkana Ark/TX
Posts: 2,446
Likes: 575
Liked 880 Times in 311 Posts
|
Re: leaking th400
You just need Flex Seal
__________________
Adger Smith (Former SS) |
|
|
|
| Liked |
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
