3rd Gen Camaro wheelie bars

Tom Goldman · 06-21-2021, 04:17 PM

The S&W bars are a good choice , they fit with no issues.
Ken Keir's mono bar is also good if you have a larger budget .

Adger Smith · 06-23-2021, 10:10 AM

If you can balance your car it might run quicker without them.
My gen 3 is about a nickel quicker without them.
It is the unsprung weight that my set up doesn't like.
I found it when I put my spare 6.50 third member in..
I took out an aluminum and installed an iron (same spool and gear ratio) Strange third member. Found that same nickel that shows up when I just mount the wheelie bars.. Ride along, no use...but if you need them there are a lot of ways to use them.

06-21-2021, 04:17 PM	#1
Tom Goldman VIP Member Join Date: Jan 2003 Location: Allentown,PA Posts: 2,478 Likes: 894 Liked 886 Times in 238 Posts	Re: 3rd Gen Camaro wheelie bars The S&W bars are a good choice , they fit with no issues. Ken Keir's mono bar is also good if you have a larger budget . __________________ Tom Goldman 1500 SG , 1506 STK

06-23-2021, 10:10 AM	#2
Adger Smith VIP Member Join Date: Dec 2001 Location: Texarkana Ark/TX Posts: 2,446 Likes: 575 Liked 880 Times in 311 Posts	Re: 3rd Gen Camaro wheelie bars If you can balance your car it might run quicker without them. My gen 3 is about a nickel quicker without them. It is the unsprung weight that my set up doesn't like. I found it when I put my spare 6.50 third member in.. I took out an aluminum and installed an iron (same spool and gear ratio) Strange third member. Found that same nickel that shows up when I just mount the wheelie bars.. Ride along, no use...but if you need them there are a lot of ways to use them. __________________ Adger Smith (Former SS)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode