|
|
|
|
11-23-2021, 08:24 PM
|
#1 |
|
Live Reporter
Join Date: Oct 2004
Location: Hickory, Ky
Posts: 10,633
Likes: 1,928
Liked 10,687 Times in 2,225 Posts
|
Re: Oil pan gasket choice for big block mopar
If you want to you can. Drop the drag link and trans. Remove flex plate and damper. While it’s off check a bearing or too. Clean and resemble. Not a piece of cake but doable.
|
|
|
| Liked |
|
11-23-2021, 11:00 PM
|
#2 |
|
Junior Member
Join Date: Oct 2012
Location: Sydney , Australia
Posts: 97
Likes: 23
Liked 43 Times in 25 Posts
|
Re: Oil pan gasket choice for big block mopar
wowser . no way Jose' !.
Thanks Larry but i might pass on that . I actually swapped in my transbrake transmission only 3 weeks ago . Had the pan off yesterday . I think its mostly wicking down a couple of bolts that line up with cap cross bolts . No time to check bearings needed to get home . Its my daily street/strip satellite . Tex |
|
|
|
11-24-2021, 07:51 AM
|
#3 |
|
Live Reporter
Join Date: Oct 2004
Location: Hickory, Ky
Posts: 10,633
Likes: 1,928
Liked 10,687 Times in 2,225 Posts
|
Re: Oil pan gasket choice for big block mopar
Sounds like a fun ride.
|
|
|
|
|
11-24-2021, 04:37 PM
|
#4 |
|
Junior Member
Join Date: Oct 2012
Location: Sydney , Australia
Posts: 97
Likes: 23
Liked 43 Times in 25 Posts
|
Re: Oil pan gasket choice for big block mopar
thanks Larry .yes a lot of fun and almost cheaper than Stock . It runs 10.20s@ 3780lbs but a few more cubes than yours
 Tex |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
