1963 - 1979 Vette four link install.

[sst7250]

FWIW we have chosen to stick with ladder bars in the gen 3 we run heads up stuff with. Car has been 1.08 60' NA with a 29.5x10.5 slick.

[SSDiv6]

Build a 1978-1980 Malibu just like the SRD-built car raced by Larry Kopp.

[Woodfin]

SS d6. I like your comment about the G body. I know from experience those are good packages.

[Woodfin]

SST 7250, I like your comment about a ladder bar. I know from experience they work very well. My reason for asking about a four link in the Vette was because of the limited space available. It is a non-issue because I have scratched the Vette idea.

[4543]

Larry, How much tire do you need? My 71 H/SA has gone 1.36 on a 9” Hoosier. My 12 bolt is one of the first conversions done when NHRA began allowing them in stock. Nothing fancy, no 4-link. I know before it got crazy with some of the setups allowed in stock others were doing the same thing and making them work. Mike McMahan 2543 H/SA

[Woodfin]

Mike, it will need to run 5.90's - 6.0's in the 1/8th at around 2900 pounds with driver. Thus, around 725 horsepower. The tire size is not so much an issue as the rear assembly strength at that performance. I think a 30 x 12 tire would be plenty. And remember this is a manual trans deal.

I realize this post is all over the place, but I have found 1975 Vette 10 miles from my shop that will check out tomorrow.

Someone mentioned cutting the rear floor out of the body. Have you seen that done?

[Ernie Neal]

[QUOTE=Someone mentioned cutting the rear floor out of the body. Have you seen that done?[/QUOTE]

Larry, I have cut up a C4

http://classracer.com/classforum/sho...light=corvette

Ernie Neal
SS354

[sst7250]

Originally Posted by Woodfin

SST 7250, I like your comment about a ladder bar. I know from experience they work very well. My reason for asking about a four link in the Vette was because of the limited space available. It is a non-issue because I have scratched the Vette idea.

No worries. We looked at possible doing the 4 link deal with short upper links. Decided against it as we have the car working well for a small block anyway. Was alot of work, with not a huge possible upside for us. Honestly they make horrible racecars for what we do.

Here is a pic of the car NOT doing what we want it too

[Ron Miller]

Originally Posted by sst7250

No worries. We looked at possible doing the 4 link deal with short upper links. Decided against it as we have the car working well for a small block anyway. Was alot of work, with not a huge possible upside for us. Honestly they make horrible racecars for what we do.

Here is a pic of the car NOT doing what we want it too

Nice Corvette. By chance do you have more build details and pictures?

[Woodfin]

Robbie, please check your message box.