Recoating piston skirts

Dyno · 03-06-2023, 12:44 PM

Tape off the piston ring area, then have them glass beaded on a lower pressure. We have had great success with Calico. That’s where I would go

mnmaxwedge · 03-06-2023, 10:15 PM

We use Elliott, Line 2 Line and Calico where I work. All 3 do a really good job. The Line 2 Line process is different than the other 2. You should read about it before you make a decision.

03-06-2023, 12:44 PM	#1
Dyno Senior Member Join Date: Dec 2002 Posts: 916 Likes: 1,140 Liked 685 Times in 204 Posts	Re: Recoating piston skirts Tape off the piston ring area, then have them glass beaded on a lower pressure. We have had great success with Calico. That’s where I would go

03-06-2023, 10:15 PM	#2
mnmaxwedge Junior Member Join Date: Dec 2019 Posts: 97 Likes: 56 Liked 172 Times in 53 Posts	Re: Recoating piston skirts We use Elliott, Line 2 Line and Calico where I work. All 3 do a really good job. The Line 2 Line process is different than the other 2. You should read about it before you make a decision.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode