Tech Inspection stories?

[Jack McCarthy]

twice ive been tossed both by travis an hes good friend

85 sports class teardown was 5-7# over valve springs travis was laying carpet in my house on tuesday .... he says as i push outta the barn still doing carpet ?? im like sure you didnt f&*k me did you he replied i tried all 3 spring testers you got bounce 3 times

like 89 ? indy at paul harvey ....
he says lets check #7 dont think weve done that cylinder yet (car has passed several teardowns) and damnit 3degrees over intake duration that lobe only ...
nhra drops duration rule jan 1st so i was LAST guy to take the duration DQ.

travis once carried a concrete block in his van to reach his short *** over the 60 fenders !

capt

[Jim Caughlin]

A few years back, I was at a Divisional and the tech guy told me I couldn't run because the rod end support on the front of my ladder bars was below the height of the top of the rear wheel. I tried to explain to him that what the rulebook actually said was that the attachment point on the rearend housing couldn't be lower than the top of the wheel. He said that I was wrong and that no suspension component could be below the bottom of the wheel in case a tire went flat. I pointed out to him that on a tube chassis car, the entire frame was below the top of the tire. Anyway, he said cut them off or don't run so I cut them off. A few weeks later, I went to the next divisional race and the tech guy not suprisingly told me that I couldn't run because I had no ladder bar rod end supports. Go figure...

[Rick J]

So I'm at a Phoenix NHRA divisional back in the day, Max Wedge guy had just set the A/SA record, I happen to stroll on by when tech guy is trying to measure the stroke with a dial caliper ..... he looks up and yells at the other tech guy - Hey, does a Max Wedge have a 4.250" stroke? 😆 🤣