10-ounce CO2 refill

[Mike Merk]

Originally Posted by Rich Biebel

Turbo Action Cheetah and the trans is a Metric T-200 reverse pattern V-Body

Biondo makes the air shifter add on and Digital Delay makes the controller

It's not legal for Stock but is working fine just for bracket racing for now.

It would be legal for Super Stock

I have basically the exact same setup - T350, Cheetah (forward pattern), Biondo solenoid, Digital Delay controller & adjustable regulator. If the pressure is below ~110 it shifts 1st to 3rd, if the pressure is 125 or above it shifts positively each gear change. In between it "hangs" on the 1 - 2 shift & slows the 330' time. The Biondo solenoid instructions align with what I've experienced regarding the 1 to 3 change stating that if this happens, increase the pressure.

I was asking all of this because I thought about switching to a K&R compressor, but if it only adjusts up to 100 PSI I'm not sure it will work for me.

[Rich Biebel]

I had similar issues with the Biondo shifting 1-3 if pressure gets to low.
The K&R pressure switch shuts off at 110lbs and does not go on until 90 or below.
I looked to see if there was a higher pressure switch I might be able to swap in but there was nothing that I felt was the right off and back on switch,pressure wise
Mines been working fine at 100-110 lbs and I just make sure the pressure is up before a run.....
I replaced my shift cable and the shifter is much easier to shift and I have not been out racing to check both the trans and the shifting issues I've been having.
Racing takes a back seat anymore.....