Push rods

[1320racer]

1. Without question I schooled Jere on my combo, my headers and he acknowledged that in the initial conversation and confirmed it again when he reached out to me sometime later.

2. Not “now”rather for over 2 decades I’ve been specing the cams for my engines as well a few friends and competitors.

3. This thread ain’t about engine assembly, cam design nor headers’

[Stan Weiss]

Originally Posted by 1320racer

1. I don?t respond to your worthless threads and neither does anyone else!

2. FYI, I?ve been ?designing?cams, specing lobes and events for my engines and friends including a few stock/super stock engines for over 2 decades.

Originally Posted by 1320racer

Without question I schooled Jere on my combo, my headers and he acknowledged that in the initial conversation and confirmed it again when he reached out to me sometime later.

Not ?now?rather for over 2 decades I?ve been specing the cams for my engines as well a few friends and competitors.

I see now that you have been called on it the "designing cams" is gone.


Again what is the peak cam acceleration on your present cam?


Have you ever looked at and understood what a Cam Dr or Cam Pro Plus report shows?


Stan

[Stan Weiss]

Originally Posted by 1320racer

1. Without question I schooled Jere on my combo, my headers and he acknowledged that in the initial conversation and confirmed it again when he reached out to me sometime later.

2. Not ?now?rather for over 2 decades I?ve been specing the cams for my engines as well a few friends and competitors.

3. This thread ain?t about engine assembly, cam design nor headers?

I see you have edited your post since I responded to it.

The thread is about Push Rods. I don't know had you talk about Push Rods without talking about opening and closing spring pressure and cam lobe design is somewhat a factor in what these pressures need to be.

Stan

[1320racer]

Originally Posted by Stan Weiss

I don't know had you talk about Push Rods without talking about opening and closing spring pressure and cam lobe design is somewhat a factor in what these pressures need to be.

WRONG again Stanley, this thread is about where, from whom to buy push rods!