GM 12 Bolt - Racepak Drive Line Sensor Bracket

[Willyracer]

I was going to mount on the yoke but would had to remove
And machine a surface for the ring

I just mounted the ring on the Tran yoke and the pickup
Off the tail shaft web. Works good.
I running a metric 200 trans

David

[Mike Semeniuk]

I built a mount, drilled holes in the webing and mounted there. I still have template I can post tomorrow

[J&S Racing]

[bestephen]

Originally Posted by J&S Racing

I like how clean this looks, Is there a special welding procedure for welding to the cast iron casing?

[J&S Racing]

Originally Posted by bestephen

I like how clean this looks, Is there a special welding procedure for welding to the cast iron casing?

That I can’t answer, I had Mark Markow do this for me. I will say the collar had to be machined down to fit the yoke.

[rboyle]

Mark Williams sells a yoke but it's about 7/16" longer with the flange for the collar.

[SGSST109E]

A mig welder or for that matter a stick welder. A housing welds easy. I have a yoke from strange the only negative it is longer so the driveshaft needs to be shorter.

[curtis reed]

Originally Posted by bestephen

I like how clean this looks, Is there a special welding procedure for welding to the cast iron casing?

TIG it with Inconel 600 filler rod.

[tavbfl]

This is how I did it for my Autometer DL driveline speed sensor.

[Glenn Briglio]

Mine is done with the sensor on the front driveshaft yoke and a bracket off the driveshaft loop.