|
11-15-2018, 09:42 PM | #22 |
Junior Member
Join Date: Aug 2018
Location: Colorado Springs Colorado
Posts: 28
Likes: 2
Liked 85 Times in 15 Posts
|
Re: 302 Chevrolet Engine Build
I turn the block 180 degrees to keep the mandrel tru. I adjust oil flow to slow down the honing rate. The 3 center mains can not be over stroked, they hone faster than 1 and 2 mains. I do use a truing sleeve on the rod hone mandrels, but I've never seen a truing sleeve for a line hone mandrel, but I just started machining. Could you post up an image of a "Line hone mandrel truing sleeve" Thanks |
|
|