CLASS RACER FORUM - View Single Post - In-Dash CO2 Refilling Connectors

voltdr · 10-10-2010, 10:12 PM

The TEE fitting is the same pipe thread as the gauge. Most likely 1/8" pipe on (male) on each end, and a -4 on the TEE side. Use the teflon hose to extend the line to the dash. Use a -4 brake line bulkhead fitting on the dash and put a -4 cap on it. On my dragster the bottle is easily accessible, so I can fill my bottle right at the regulator w/o the extra line. Hope this helps.

10-10-2010, 10:12 PM	#4
voltdr Senior Member Join Date: Jan 2008 Location: Texas Posts: 706 Likes: 77 Liked 100 Times in 51 Posts	Re: In-Dash CO2 Refilling Connectors The TEE fitting is the same pipe thread as the gauge. Most likely 1/8" pipe on (male) on each end, and a -4 on the TEE side. Use the teflon hose to extend the line to the dash. Use a -4 brake line bulkhead fitting on the dash and put a -4 cap on it. On my dragster the bottle is easily accessible, so I can fill my bottle right at the regulator w/o the extra line. Hope this helps. Last edited by voltdr; 10-10-2010 at 10:14 PM. Reason: added more info