Quote:
Originally Posted by impstocker
Hey Mark,
I was just catching up on some of these post. What do you mean by-
"You really want a ball type pivot on the bottom with a strut rod type suspension."
Are you talking about a Heim type joint at the end of the strut rod where it goes through the frame up front?
I will probaly use a rubber bottom bushing with the serrates removed, do you think this would be a better option so I can address the caster issue?
Thanks for any input-
Will Lamprecht
Div 1 65 imp I/SA
|
No, I mean the single lower control arm inner bushing on those cars..You shouldn't put in a bushing that doesn't allow fore and aft movement of the lower ball joint...for adjustment purposes.
The heim on the end of the strut....I'm not sure where we left off on that controversy.