Front End Suspension, NHRA Rule Question

[impstocker]

Originally Posted by Mark Yacavone

Will, only problem I see with solid lowers is you can't pull the lower ball joint forward to gain positive caster..You'll have to do it all on the top.
Just hope that both side "center" in the same place.
You really want a ball type pivot on the bottom with a strut rod type suspension.
Take a look at some of the stuff for early Mustangs or Chevy II's
One other thing..THICKER body bushings give you more room between the carb and the hood.

Hey Mark,
I was just catching up on some of these post. What do you mean by-
"You really want a ball type pivot on the bottom with a strut rod type suspension."
Are you talking about a Heim type joint at the end of the strut rod where it goes through the frame up front?

I will probaly use a rubber bottom bushing with the serrates removed, do you think this would be a better option so I can address the caster issue?
Thanks for any input-
Will Lamprecht
Div 1 65 imp I/SA