'66 Malibu N/SA

Dave Muller · 05-07-2017, 07:28 PM

I spent most of yesterday reworking the inside rear corners of the rear fenderwells. I've got an additional 1/2" plus clearance on each side now. I think that will work okay, if there's an issue I should still be able to get slightly smaller diameter slicks in time for Fontana.

Today I put in the interior:

At this point I consider the build to be essentially complete. I do have to hit the hardware store tomorrow after which I can install the belts, and the numbers still have to go on. But that about does it! Friday night I take it to Wild Horse.

05-07-2017, 07:28 PM	#11
Dave Muller Member Join Date: Apr 2014 Location: Mesa, AZ Posts: 497 Likes: 162 Liked 223 Times in 73 Posts	Re: '66 Malibu N/SA I spent most of yesterday reworking the inside rear corners of the rear fenderwells. I've got an additional 1/2" plus clearance on each side now. I think that will work okay, if there's an issue I should still be able to get slightly smaller diameter slicks in time for Fontana. Today I put in the interior: At this point I consider the build to be essentially complete. I do have to hit the hardware store tomorrow after which I can install the belts, and the numbers still have to go on. But that about does it! Friday night I take it to Wild Horse. Last edited by Dave Muller; 07-08-2017 at 05:25 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode