C4 Corvette build for Superstock I-J-K

[Ernie Neal]

Originally Posted by Robert Simpson

Ernie, great build I like the layout. Would you happen to have any pictures of the clutch linkage installed? I am thinking that you are using a bell crank under the floor pan or under the dash dropping down to the clutch fork?

Thanks

Robert,
my clutch linkage is inside the car similar to what old 55-57 Chevys were. I had 1 shot of one of the ends I made to hold the cross shaft. I used bearings on each end. These are welded to the dash bar. The rod drops through the floor just past the accelerator pedal.

The other picture is all the pieces that comprise the linkage before welding.

Ernie