PG &TH350 tailshaft bushings

[Tom Goldman]

Originally Posted by 63corvette

Just an FYI and you may be aware of this but the yokes are also made oversize and under size from std.
That is especially the case when you try to use a yoke made for a roller bearing on a bushing tail shaft.
There is a difference in size from the bushing to the roller bearing on the ID.

Yes I am aware ,Actually the roller diameter yoke will fit these bushings as it has a smaller O.D....This is with the normal standard yoke. ......I normally do about 8 to 10 glides a month,most using the non roller tail. ....Bill, thanks for the link ,I'm going to check that out. .......This is more of an annoiance than a major problem, but the babbet bearings were also more forgiving for wear on the yoke. ....Tom