U/SA 302 ffffford build

goinbroke2 · 05-30-2024, 05:07 PM

4th sentence says “must retain stock diameter and angle + - 1*”. But the 4th sentence from the bottom says “any valve job accepted”?

Well i did 4 angles (cant find my 75* ) 15 in the chamber, 30 below that, 45 seat and 60* in the throat. Im pulling my hair out because the flash and casting crap as well as the lip left from the 15 cut is killing flow but i cant legally remove it. Stock casting SUCK!! Lol!
So much easier to make power when you blend, lol.

05-30-2024, 05:07 PM	#23
goinbroke2 Senior Member Join Date: Mar 2002 Location: NS CANADA Posts: 877 Likes: 1,510 Liked 371 Times in 146 Posts	Re: U/SA 302 ffffford build 4th sentence says “must retain stock diameter and angle + - 1”. But the 4th sentence from the bottom says “any valve job accepted”? Well i did 4 angles (cant find my 75 ) 15 in the chamber, 30 below that, 45 seat and 60* in the throat. Im pulling my hair out because the flash and casting crap as well as the lip left from the 15 cut is killing flow but i cant legally remove it. Stock casting SUCK!! Lol! So much easier to make power when you blend, lol. __________________ Jim Miller 103 U/SA Last edited by goinbroke2; 05-30-2024 at 05:10 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode