TCI Competition series TH350 Problems! - Page 2

dartman · 03-06-2010, 08:56 AM

check the shifter cable,see if the adjustment is right.

btw did you have the low/rev sprage out,it can go in backwards.

The Hawk · 03-06-2010, 03:41 PM

I agree,check the shifter linkage. On a TH 350,if you pull the lever back into low gear,and then a little further back it will allow fluid through a different passage and act like a trans brake. Lane

HotRodGMC68 · 03-09-2010, 04:01 PM

the sprg was not messed with and went in as it was when it came out. I checked the shifter cable adjustment and it was right on per Hurst instructions.

When we tested the pressures I crawled under the truck, removed the shift cable and shifted it by hand at the transmission, letting it settle in the detents. no change

03-06-2010, 08:56 AM	#11
dartman Member Join Date: Oct 2005 Location: N.S. CANADA Posts: 498 Likes: 155 Liked 68 Times in 41 Posts	Re: TCI Competition series TH350 Problems! check the shifter cable,see if the adjustment is right. btw did you have the low/rev sprage out,it can go in backwards. __________________ 1231 FS/D Drag Pak 1231 E/SA 71 Demon Kelly MacKay Last edited by dartman; 03-06-2010 at 09:24 AM.

03-06-2010, 03:41 PM	#12
The Hawk VIP Member Join Date: Mar 2003 Location: Littleton,Colorado Posts: 1,189 Likes: 0 Liked 248 Times in 106 Posts	Re: TCI Competition series TH350 Problems! I agree,check the shifter linkage. On a TH 350,if you pull the lever back into low gear,and then a little further back it will allow fluid through a different passage and act like a trans brake. Lane __________________ Lane Weber It`s Not What You Drive That Wins....It`s How You Drive It

03-09-2010, 04:01 PM	#13
HotRodGMC68 Junior Member Join Date: Oct 2009 Posts: 7 Likes: 0 Liked 0 Times in 0 Posts	Re: TCI Competition series TH350 Problems! the sprg was not messed with and went in as it was when it came out. I checked the shifter cable adjustment and it was right on per Hurst instructions. When we tested the pressures I crawled under the truck, removed the shift cable and shifted it by hand at the transmission, letting it settle in the detents. no change