1964 Dodge 330 "Race Hemi"

Gary Bouman · 03-25-2014, 08:31 PM

Tom,great looking car you are building as always. May I ask what you used for the side bar protectors? Are those the carbon fiber from Bickel or such or vinyl and are you satisfied? Thanks Gary

Charlie A · 03-25-2014, 08:50 PM

Charlie A · 03-25-2014, 08:52 PM

Tom Nolan · 04-01-2014, 04:15 PM

Gary, sorry it has taken so long to get back to you but I have been gone for a couple of weeks and missed your question. The carbon fiber bar protectors are from Bickle. I fit them with a cut off wheel and die grinder until I'm satisfied with the fit. Then I put masking tape on the bars for a guide, and to control any miss guided glue. I put contact cement on the bar and carbon fiber pieces let tack up for a couple of minutes then put them in place then tie wrap down for a day. Peel off the masking tape and remove the tie wraps and it looks great!

03-25-2014, 08:31 PM	#1
Gary Bouman Junior Member Join Date: Aug 2010 Posts: 40 Likes: 651 Liked 18 Times in 9 Posts	Re: 1964 Dodge 330 "Race Hemi" Tom,great looking car you are building as always. May I ask what you used for the side bar protectors? Are those the carbon fiber from Bickel or such or vinyl and are you satisfied? Thanks Gary

03-25-2014, 08:50 PM	#2
Charlie A VIP Member Join Date: Sep 2010 Location: Mississippi Gulf Coast Posts: 2,483 Likes: 68 Liked 87 Times in 63 Posts	Re: 1964 Dodge 330 "Race Hemi"

03-25-2014, 08:52 PM	#3
Charlie A VIP Member Join Date: Sep 2010 Location: Mississippi Gulf Coast Posts: 2,483 Likes: 68 Liked 87 Times in 63 Posts	Re: 1964 Dodge 330 "Race Hemi" Last edited by Charlie A; 03-25-2014 at 08:55 PM.

04-01-2014, 04:15 PM	#4
Tom Nolan Member Join Date: Dec 2001 Location: Lacombe, Alberta, Canada Posts: 182 Likes: 0 Liked 64 Times in 11 Posts	Re: 1964 Dodge 330 "Race Hemi" Gary, sorry it has taken so long to get back to you but I have been gone for a couple of weeks and missed your question. The carbon fiber bar protectors are from Bickle. I fit them with a cut off wheel and die grinder until I'm satisfied with the fit. Then I put masking tape on the bars for a guide, and to control any miss guided glue. I put contact cement on the bar and carbon fiber pieces let tack up for a couple of minutes then put them in place then tie wrap down for a day. Peel off the masking tape and remove the tie wraps and it looks great!