My 88 Olds wagone U/SA 10 Pennies

[Dwight Southerland]

Jeff, I really appreciate the effort you are doing to document your costs as you go. At the end of the project, it will be a great resource for anyone considering a budget build. Thank you for sharing and working so diligently.

[Jeff Stout]

Originally Posted by Dwight Southerland

Jeff, I really appreciate the effort you are doing to document your costs as you go. At the end of the project, it will be a great resource for anyone considering a budget build. Thank you for sharing and working so diligently.

Thank you for the kind words. I know this is not the state of the art build and it is not the best pieces money can buy. But I feel I can run 7-8 under and be bracket race competitive. Just think no roll bar to climb over, full soft bench seat, room for all your friends and might get as much attention in staging lanes as a FX car. LOL

[Dwight Southerland]

Originally Posted by Jeff Stout

Thank you for the kind words. I know this is not the state of the art build and it is not the best pieces money can buy. But I feel I can run 7-8 under and be bracket race competitive. Just think no roll bar to climb over, full soft bench seat, room for all your friends and might get as much attention in staging lanes as a FX car. LOL

I have built budget cars that took a lot of thinking and expensive cars that took a lot of money. The ones that were the most fun were those I did like yours.

[Jeff Stout]

Made a mistake today on guessing how much to cut from head to get chamber down to proper CC. Way to far to get back to spec. Had to buy a used head for 60.00 and received cam bearings today 11.50 New total $3555.50

[SSDiv6]

Originally Posted by Jeff Stout

Made a mistake today on guessing how much to cut from head to get chamber down to proper CC. Way to far to get back to spec. Had to buy a used head for 60.00 and received cam bearings today 11.50 New total $3555.50

Jeff,

I usually takes about 0.005" ~ 0.006" of deck surface removal per CC of combustion-chamber volume for an Oldsmobile cylinder head.
However, this is a guideline and you need to constantly check it.

[Dwight Southerland]

Jeff -
If you have a burette available, PM me and I will show you an easy way to get real close on the CC volume on one cut.

[Mark Yacavone]

All the new NHRA phony baloney valve job all done, already?