Edelbrock Super Victor CNC 2825

Tom Goldman · 01-05-2018, 09:59 AM

Drew, I cant say about the SBC manifold, but if it's anything like the BBC version, there is very little beyond the port match and some very minor machining at the carb flange .
The gasket/port match was dead on to my AFR heads ,so that was nice ,but I saw no other benefit other than it saved me the work of matching.
I later did some radius work in the plenum and further matching to the throttle stop base along with completely finishing the runners. this netted about 1/2 MPH .
Overall the base manifold was better than previous non Edlebrock manifolds I ran.

01-05-2018, 09:59 AM	#2
Tom Goldman VIP Member Join Date: Jan 2003 Location: Allentown,PA Posts: 2,478 Likes: 894 Liked 886 Times in 238 Posts	Re: Edelbrock Super Victor CNC 2825 Drew, I cant say about the SBC manifold, but if it's anything like the BBC version, there is very little beyond the port match and some very minor machining at the carb flange . The gasket/port match was dead on to my AFR heads ,so that was nice ,but I saw no other benefit other than it saved me the work of matching. I later did some radius work in the plenum and further matching to the throttle stop base along with completely finishing the runners. this netted about 1/2 MPH . Overall the base manifold was better than previous non Edlebrock manifolds I ran. __________________ Tom Goldman 1500 SG , 1506 STK