Input needed on Willy’s Restrictor Plate

Lenny5160 · 02-15-2018, 04:18 PM

From what I've read, you may or may not be able to kill enough with the Willy's plate. Right on the edge.

EZ Plate will work, but you'll need to carry a variety of plates to dial the car rather than just turning a bolt on the Willy's.

jmcarter · 02-15-2018, 10:38 PM

Thanks guys, confirms what I was thinking, hate to kill MPH but if I buy the car I may just unhook the four barrel and see if it will still cut a light and if halfway close use weight to fine tune. This would be a one race deal, guys will be fighting to line up with me first round....get your first round duck right here! If I buy the car will get one of the Sinnett stops and test, test, test.

Thanks again.

02-15-2018, 04:18 PM	#1
Lenny5160 Senior Member Join Date: Nov 2015 Location: Inver Grove Heights, MN Posts: 898 Likes: 604 Liked 431 Times in 224 Posts	Re: Input needed on Willy’s Restrictor Plate From what I've read, you may or may not be able to kill enough with the Willy's plate. Right on the edge. EZ Plate will work, but you'll need to carry a variety of plates to dial the car rather than just turning a bolt on the Willy's. __________________ S/ST 51 S/C 53

02-15-2018, 10:38 PM	#2
jmcarter VIP Member Join Date: Dec 2008 Location: Richmond Hill GA (and Port Ludlow WA) Posts: 4,308 Likes: 2,418 Liked 3,227 Times in 981 Posts	Re: Input needed on Willy’s Restrictor Plate Thanks guys, confirms what I was thinking, hate to kill MPH but if I buy the car I may just unhook the four barrel and see if it will still cut a light and if halfway close use weight to fine tune. This would be a one race deal, guys will be fighting to line up with me first round....get your first round duck right here! If I buy the car will get one of the Sinnett stops and test, test, test. Thanks again. __________________ Jim Carter 2340 Super Stock 2340 SST/2340 Stock Set another place at the table