|
![]() |
#1 |
Live Reporter
Join Date: May 2006
Location: Dripping Springs, Tx
Posts: 2,700
Likes: 185
Liked 507 Times in 128 Posts
|
![]()
If you have a 31x13 radial tire how much would it hurt to put the tire on a 15x12 wheel vs a 15x14 wheel? Thanks
__________________
Ed Carpenter 2005 Chevy Cobalt A/SM Race Engine Development |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Mar 2002
Location: Woodburn, Or
Posts: 637
Likes: 70
Liked 694 Times in 209 Posts
|
![]()
Are you thinking about trying radials with a stick? Not a good idea, I don't know anyone who is having any luck with manual trans applications. My experience was that they hook sometimes and about every 5th run, it would just blow the tires off. Not a controlled spin either, pretty much a total abort situation.
|
![]() |
![]() |
![]() |
#3 |
VIP Member
Join Date: Jun 2009
Location: Boulder City, Nevada 89005
Posts: 2,546
Likes: 2,244
Liked 1,888 Times in 581 Posts
|
![]()
I have seen no difference between 12 and 14 inch wheels
on 13/31 Tires
__________________
John Irving 741 Stock 741 Super Stock |
![]() |
![]() |
Liked |
![]() |
#4 |
Junior Member
Join Date: Apr 2016
Posts: 54
Likes: 1
Liked 18 Times in 15 Posts
|
![]()
Radials with a stick requires a different approach regarding the clutch and gearing. The clutches you guys typically run would not be my 1st choice, and something like my ClutchTamer is also needed to control the hit.
Since a radial needs to be dead hooked, there's no need for a deep 1st gear ratio to control tire spin. Less ratio in 1st means less torque available to break the tires loose, but that loss of torque at the tire is offset by spending more time in the gear with the most multiplication. More even gear splits also improve recovery rpm, with the side benefit of less energy discharge on the gearchange. Less energy discharge on the shift lowers the risk of breaking the radials loose. ...You need enough mass in the clutch so that it doesn't overheat while you are leaning on it, also need one that doesn't depend on centrifugal assist to hold. ...With a properly controlled clutch hit, you won't need a 2-step and will be able to launch off the limiter without breaking the radials loose. Higher launch rpm means more energy available to get the car moving when the clocks are running. ...Wheelspeed spikes after WOT clutchless shifts need to be minimized with radials, bring those under control by adjusting clutch base. Grant
__________________
Grant website- http://ClutchTamer.com We make your non-adjustable clutch...ADJUSTABLE! |
![]() |
![]() |
Liked |
![]() |
#5 | |
Junior Member
Join Date: Apr 2017
Posts: 93
Likes: 19
Liked 30 Times in 16 Posts
|
![]() Quote:
|
|
![]() |
![]() |
![]() |
#6 |
Senior Member
Join Date: Sep 2016
Posts: 846
Likes: 151
Liked 278 Times in 153 Posts
|
![]()
From everything I've tried with radials, they always liked a wider rim than the tire. When using a narrower rim I had trouble with bad wobble and less contact patch.
|
![]() |
![]() |
Liked |
![]() |
#7 |
Veteran Member
Join Date: Mar 2005
Location: Sand Springs, OK
Posts: 8,132
Likes: 896
Liked 389 Times in 168 Posts
|
![]()
I use the 13" X 31", on 14" wheels, so I can run more air (13 to 14 psi).
__________________
Ed Wright 4156 SS/JA Last edited by Ed Wright; 03-20-2019 at 04:11 PM. |
![]() |
![]() |
![]() |
#8 |
Junior Member
Join Date: Apr 2017
Posts: 93
Likes: 19
Liked 30 Times in 16 Posts
|
![]()
,Wide rim. If you can manage deformation early, you're managing spikes. If you can manage W/S spikes, the potential for leaving tracks could present itself, bridging the gap. Wider wheels than normal?
Last edited by Mike Rietow; 03-20-2019 at 02:58 PM. |
![]() |
![]() |
![]() |
#9 |
Veteran Member
Join Date: Mar 2005
Location: Sand Springs, OK
Posts: 8,132
Likes: 896
Liked 389 Times in 168 Posts
|
![]()
Mike, what is a "W/S spike"? I've never heard that term.
__________________
Ed Wright 4156 SS/JA |
![]() |
![]() |
![]() |
#10 |
Junior Member
Join Date: Apr 2017
Posts: 93
Likes: 19
Liked 30 Times in 16 Posts
|
![]()
After the car leaves pause, look in the groove Ed. You can get away with it, bias tire. No wheely bar it's essential to not getting on the bumper. Wheel speed spike.
Last edited by Mike Rietow; 03-20-2019 at 11:37 PM. |
![]() |
![]() |
![]() |
|
|