Dumbo The Flying Elephant

denbreeden · 08-06-2019, 08:42 AM

Quote:

Originally Posted by Larry Hill

It's amazing how a good night sleep changes a persons outlook on a problem that was so large yesterday. Me using poor judgement almost ruined the threads in the aluminum block where the trans mounts. The fix was remove casting flashing from the trans. Smooth the depressions for the bolts in trans bellhousing. Remove steel bushings and give them .015'' more radial clearance. Slot the shield to move bushing to the centerline of the bolt hole. Enlarging the hole in the shield wont work because the bushing will fall out during installation. The shield floats on the bushings. Straighten the damaged threads in the block. Clean threaded holes, examine bolts for burs and damage threads, repair if necessary, antiseaze, and test fit. Install trans and install bolts with fingers at least four turns in, to verify bolts are not cross threaded. What could be more simple than that?

Does anyone make a locking dip stick that bolts up to a 727 with a shield installed, that does not require modification?

Play time is over back to work!

I think mine is a Lokar, flexible braided line for the tube. I'll try and send a picture of mine.

Dennis Breeden

Larry Hill · 08-06-2019, 09:59 AM

Thanks

Mack Reeves · 08-06-2019, 04:43 PM

Quote:

Originally Posted by denbreeden

I think mine is a Lokar, flexible braided line for the tube. I'll try and send a picture of mine.

Dennis Breeden

Larry, mine is a Lokar as well.. One thing is make sure the full line is really full.. I burnt two trannys up before realizing full on the dip stick isn't really full.. I took the tranny pan off and marked the dip stick at the base of the tranny.. Took a file to it.. Now fill to that mark.. all has been well since.. Just what happened to me.. Mack

Frank Castros · 08-06-2019, 06:25 PM

Great advice provided by Mack, but Larry you are into Dumbo very, very deep. I can't wait to see the fruits of your dedication and labor.

Larry Hill · 08-07-2019, 06:06 AM

From Joel at "Joel's on Joy", who credits Jeff Taylor; always check trans fluid with car in gear with some one holding the brake.

08-06-2019, 09:59 AM	#2
Larry Hill Live Reporter Join Date: Oct 2004 Location: Hickory, Ky Posts: 10,670 Likes: 1,967 Liked 10,898 Times in 2,255 Posts	Re: Dumbo The Flying Elephant Thanks __________________ IHM Used Parts https://ihmusedparts.com 888-821-1817

08-06-2019, 06:25 PM	#4
Frank Castros VIP Member Join Date: Nov 2001 Location: The Lowcountry. Posts: 3,004 Likes: 2,674 Liked 2,753 Times in 974 Posts	Re: Dumbo The Flying Elephant Great advice provided by Mack, but Larry you are into Dumbo very, very deep. I can't wait to see the fruits of your dedication and labor.

08-07-2019, 06:06 AM	#5
Larry Hill Live Reporter Join Date: Oct 2004 Location: Hickory, Ky Posts: 10,670 Likes: 1,967 Liked 10,898 Times in 2,255 Posts	Re: Dumbo The Flying Elephant From Joel at "Joel's on Joy", who credits Jeff Taylor; always check trans fluid with car in gear with some one holding the brake. __________________ IHM Used Parts https://ihmusedparts.com 888-821-1817