|
09-13-2008, 10:09 PM | #1 |
Junior Member
Join Date: Feb 2002
Location: Omro, WI
Posts: 64
Likes: 0
Liked 2 Times in 2 Posts
|
ZZ4 And Fast Burn Headers
I have read that the ZZ4 and Fast Burn Cylinder heads have the exhaust port roof .100 taller than standard heads. Has anyone run into a problem finding headers that fit this port layout with 5/8 or 3/4 tubes. If not, what do you do???
Thanks! Randy |
09-13-2008, 11:03 PM | #2 |
VIP Member
Join Date: Feb 2003
Location: Glendale, Arizona
Posts: 2,991
Likes: 693
Liked 1,457 Times in 543 Posts
|
Re: ZZ4 And Fast Burn Headers
No problems when using Hedman Headers. They make Headers to fit the taller exhaust ports in 5/8. 3/4 and 7/8.
|
09-14-2008, 07:39 AM | #3 |
Member
Join Date: Dec 2001
Location: Ontario Canada
Posts: 361
Likes: 110
Liked 7 Times in 5 Posts
|
Re: ZZ4 And Fast Burn Headers
No problem with the ZZ4 , its the fastburn . We elongated the header bolt holes and it worked ok on our car . We had Hooker 1 3/4 headers . Hope this helps . Mike
|
09-14-2008, 10:25 PM | #4 |
Junior Member
Join Date: Feb 2002
Location: Omro, WI
Posts: 64
Likes: 0
Liked 2 Times in 2 Posts
|
Re: ZZ4 And Fast Burn Headers
Thank You SSDiv6 and Mike. I couldn't get an answer around here, most didn't know there was a difference. Thanks Again! Randy
|
|
|