light weight spool & gears
 

who makes good light weight spool & gears

Re: light weight spool & gears
 

Mark Williams aluminum spool. They also lighten gears.

Re: light weight spool & gears
 

Moser engineering///// the best !!!!!

Re: light weight spool & gears
 

I would second the moser stuff. If you use the moser alum spool you will most likely have to send them your axles to have the splines cut a little longer as they run the splines in the spool all the way from one end to the other. It cost a little more to do it this way but looks to make it alot stronger and less likely to strip the splines out of the alum spool as I have seen with some of the others.

Re: light weight spool & gears
 

Mark Williams sets the standard that others shoot for. I have run the MW aluminum spool and light weight axles since 1999 thousands of hits never a problem. That is with a 7000 rpm stick shift launch. Now that the car is sold and has an slush-o-matic in it the parts should last forever.

Re: light weight spool & gears
 

M/W is far better quality than Moser..but more expensive too..used both..no real problems with Moser...I just like to have better quality stuff...

Re: light weight spool & gears
 

Mark Williams has my vote. Mike Pustelny from MPR is a dealer for them and he can get you the best prices on their products. 810-798-8998.

Re: light weight spool & gears
 

Not trying to hyjack the thread but i was wondering. How much has anyone picked up going from a normal 30 spline moser kit to a good light weight package? I know its making your rotating parts lighter which is always a good thing but how much will it actually help. Also anything about ceramic in the rear?

Re: light weight spool & gears
 

Guys i'm not trying to stir the pot here. But in my 0pinion the moser stuff , isn't really that nice i think their quality is poor . If you want cheap than go with Moser . I have run a chassis shop for nearly 20 years, and have used parts from Moser ,Stange, and Mark Williams. The M/W is stuff is very well made but kinda exspensive . the parts from Strange eng. are very well made , and priced much better. My first choice is always Strange.

Re: light weight spool & gears
 

Moser Aluminum spool lasted me for about 20 runs and then the ring gear side broke. This was last year at the Memphis Tn. points meet. I replaced the spool with a steel Moser spool and put many runs on it without a problem.