CLASS RACER FORUM - View Single Post - Source a Small Journal SBC 350" Crankshaft

Dwight Southerland · 10-15-2010, 10:08 AM

I don't know if there is a readily available small journal aftermarket crank with that stroke. It is not difficult to have a 350 crankshaft machined to fit. If you do that, you could then use small journal rods to make the historically infamous "9/16 stroker" and make 368 cubic inches. Tom Meyer is correct, you should check clearance in the crank case before you start assembling.

10-15-2010, 10:08 AM	#6
Dwight Southerland VIP Member Join Date: Dec 2001 Location: Arkansas - In the middle of everything. Posts: 2,001 Likes: 64 Liked 780 Times in 194 Posts	Re: Source a Small Journal SBC 350" Crankshaft I don't know if there is a readily available small journal aftermarket crank with that stroke. It is not difficult to have a 350 crankshaft machined to fit. If you do that, you could then use small journal rods to make the historically infamous "9/16 stroker" and make 368 cubic inches. Tom Meyer is correct, you should check clearance in the crank case before you start assembling.