08-19-2023, 06:19 PM
|
#1
|
|
Senior Member
Join Date: Feb 2008
Location: Georgetown, Indiana (close to Louisville, KY)
Posts: 776
Likes: 530
Liked 230 Times in 106 Posts
|
Re: Roller Cams in Stock Eliminator?
Quote:
Originally Posted by Plyguy63
My car was stored for 26 years and 4 years ago started to update the car somewhat (call me stupid). Well bodywork, paint, trans, converter, the list goes on. So decided to put it in C/SA from B/SA. Can't run with those anymore. So it's a 63 Max Wedge wagon and got to the motor (flat tappet). New Bullet cam $760, tool steel DLC coated lifters $1600, pushrods, etc, etc. Ready for the dyno. My point is I don't want a rule change now to roller lifters after all the money I have spent. Just my opinion. Have read most of the posts on this and there are good reasons for and against a rule change.
|
Not wishing any bad on ya but if you haven't had on Dyno yet you might have spoke too soon. Good Luck.
|
|
|