B/RB Chrysler Valley Pan Bolt Pattern Dimensions

[Michael K]

Originally Posted by cutta

Okay, its funny how things can seem simple to you but not to others lol. Anyway, here is a picture of a valley pan to help connect the dots so to speak.

In the schematic I laid out the basic bolt layout of the valley pan and drew a line through the centers so as to indicate they sit on an angle. Imagine my schematic laid over the pic of the valley pan where the wholes line up with one another. This should make things more clear.

Doesn't there need to be a center line for a point of reference to get the measurements that you are asking for? Would that be a line between the two center hold down bolt holes on the B / RB block?

[cutta]

Originally Posted by Michael K

Doesn't there need to be a center line for a point of reference to get the measurements that you are asking for? Would that be a line between the two center hold down bolt holes on the B / RB block?

Well, since the bolt are just in reference to each other, you only need to reference the valley pan bolt holes relative to one another. The center bolt holes are centered on the crank centerline and block center so I only need the measurements relative to each bolt hole.

[GTX JOHN]

I got it.........................I will measure both Decks when I
get back from Mopar Spring Fling (Monday) . Maybe someone
else will have time before that to get the measurements,

[cutta]

Originally Posted by GTX JOHN

I got it.........................I will measure both Decks when I
get back from Mopar Spring Fling (Monday) . Maybe someone
else will have time before that to get the measurements,

I will get those measurements this weekend since I'm going home this weekend for mothers day. Thats where I have access to all of our mopar engine stuff. During the week I'm three hours away so I don't have access. Anyway, I will post that info if I get to it first.