Ford wheel stud knurls?

Robert Swartz · 07-13-2014, 07:57 PM

Having not worked on Ford stuff for better than 30 some odd years. These wheel studs are giving me fits. I found out there are both .593 and .615 knurls for press in wheel studs. I now have a good collection of extra studs, LOL!

Wanted to start getting ready to do the front brakes on my car. I pressed out the studs in a new set of front rotors. Had sets of both of the above, neither of those fit the hole. Measured the studs from the rotor, they measure .553? OK, gimmee some guidance here. I know I'm not the first person to run into this. Just looking through the catalogues, I don't see anything listed. I'm not opposed to reaming out the holes. Past experience doing this has been mixed results.

07-13-2014, 07:57 PM	#1
Robert Swartz Senior Member Join Date: Aug 2008 Location: Nineveh, Indiana Posts: 512 Likes: 0 Liked 3 Times in 3 Posts	Ford wheel stud knurls? Having not worked on Ford stuff for better than 30 some odd years. These wheel studs are giving me fits. I found out there are both .593 and .615 knurls for press in wheel studs. I now have a good collection of extra studs, LOL! Wanted to start getting ready to do the front brakes on my car. I pressed out the studs in a new set of front rotors. Had sets of both of the above, neither of those fit the hole. Measured the studs from the rotor, they measure .553? OK, gimmee some guidance here. I know I'm not the first person to run into this. Just looking through the catalogues, I don't see anything listed. I'm not opposed to reaming out the holes. Past experience doing this has been mixed results. __________________ Robert Swartz - Swartz & Lane 66 Chevy II Pro 95 Achieva EF/SA, 78 Mustang II U/SA (work in progress) #354 stock

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode