Single wheelie bar

Bill Grubbs · 05-28-2009, 11:34 AM

The bottom mount on our wheelie bars is for the single tube. It was designed this way since it is in tension, the two upper bars are in compression which for a single bar would be a significant failure point.
The lower bar is mounted to a 4130 tube bent in a half moon, attached to the housing at either end of the center section, and then also in the middle to the center section. It almost looks as if it forms a cradle for the centersection.

Like I said before This is only my opinion, but it is the reason and way it is done on our car.

Bill

05-28-2009, 11:34 AM	#5
Bill Grubbs Member Join Date: Oct 2002 Location: Magnolia, Texas Posts: 416 Likes: 3 Liked 564 Times in 66 Posts	Re: Single wheelie bar The bottom mount on our wheelie bars is for the single tube. It was designed this way since it is in tension, the two upper bars are in compression which for a single bar would be a significant failure point. The lower bar is mounted to a 4130 tube bent in a half moon, attached to the housing at either end of the center section, and then also in the middle to the center section. It almost looks as if it forms a cradle for the centersection. Like I said before This is only my opinion, but it is the reason and way it is done on our car. Bill Last edited by Bill Grubbs; 05-28-2009 at 01:26 PM.