santhuff / control arm modification question

Mike Pearson · 06-25-2012, 04:29 PM

I dont have a picture. I used a hole saw to cut out the entire center of the a arm then I welded in 2 new tabs to bolt the shock to. The shock needs to move outward to give enough room for the adjustment knob at the bottom of the shock. I pulled the a arms out to do the mods. I also used the bracket supplied by Santhuff for the lower mount to the a arm. It was a pretty easy install if you can weld and fabricate. you will also need a snubber so the shocks will not extend too far. Great shocks. They will absolutly control the front end bounce.

06-25-2012, 04:29 PM	#2
Mike Pearson VIP Member Join Date: Mar 2007 Posts: 2,451 Likes: 615 Liked 1,937 Times in 582 Posts	Re: santhuff / control arm modification question I dont have a picture. I used a hole saw to cut out the entire center of the a arm then I welded in 2 new tabs to bolt the shock to. The shock needs to move outward to give enough room for the adjustment knob at the bottom of the shock. I pulled the a arms out to do the mods. I also used the bracket supplied by Santhuff for the lower mount to the a arm. It was a pretty easy install if you can weld and fabricate. you will also need a snubber so the shocks will not extend too far. Great shocks. They will absolutly control the front end bounce. __________________ Mike Pearson 2485 SS