HELP Polishing SS Headers

ron mattson · 02-16-2009, 05:37 PM

tom is right if you want a serious chrome type finish you will need to use some type of rouge, the
3m discs will get you to a very fine satin finish with no surface defects. if you go over the welds with
a tig torch after this process it leaves a very cool blue weld at each joint that looks great just remember
to inner purge with argon or similar gas to keep the inside free of contamination..

02-16-2009, 05:37 PM	#4
ron mattson Member Join Date: Nov 2005 Location: cloquet mn Posts: 466 Likes: 17 Liked 67 Times in 30 Posts	Re: HELP Polishing SS Headers tom is right if you want a serious chrome type finish you will need to use some type of rouge, the 3m discs will get you to a very fine satin finish with no surface defects. if you go over the welds with a tig torch after this process it leaves a very cool blue weld at each joint that looks great just remember to inner purge with argon or similar gas to keep the inside free of contamination..

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode